Skip to content
The San Antonio Plumber (726) 200-5953

Faucet Repair in San Antonio, TX

We repair dripping, loose, leaking, and low-flow faucets across San Antonio.

Call (726) 200-5953 Ask a question

A plumber kneeling at an open kitchen cabinet, turning a red pipe wrench on the white P-trap under the sink

In older homes around Alamo Heights, Olmos Park, and Terrell Hills, a handle that wiggles or a spout that keeps making drops after it is turned off often points to worn parts inside an aging faucet. Mineral buildup on the screen at the end of the spout can also leave your kitchen or bathroom sink with a weak, uneven stream.

We repair faucets with worn handle parts, damaged seals, blocked screens, and leaks around the base or under the sink cabinet. A slow drip may not stop your sink from being used, but faucet repair should not be put off for long because a worn seal can waste water and a leak below the counter can swell cabinet wood or damage the floor.

Dripping spout and loose handle

A faucet that drips from the spout after both handles are off is one of the most common calls we receive. You may also notice a handle that spins without changing the water, takes several turns before water starts, or feels stiff when you move it from cold to hot.

Water collecting around the faucet base is another distinct problem. The puddle may appear only while the spout is running, then seep beneath the trim ring and into the sink cabinet instead of falling into the basin.

A weak stream, water spraying sideways, or a pull-down head that will not switch back from spray can come from the small screen at the spout, the hose, or the control parts behind the handle. These symptoms can look similar from the counter, but the failed part, access at the sink, and replacement needed can make each repair a different job.

Valve inspection at the sink

We begin the inspection by running the faucet, checking the spout, handle movement, base, spray hose, and supply connections below the sink. We check whether the shutoff valves hold, look for moisture in the cabinet, and measure water pressure where the fixture allows; residential supply pressure commonly falls between 40 and 80 psi.

Removing a handle and trim assembly lets us inspect the inside control part, called a cartridge, along with seals, washers, and retaining hardware. A basic inspection and common repair can often take 20 to 60 minutes, depending on corrosion, the fixture design, and whether the shutoff valves work.

We can usually replace a common seal, internal handle part, spout screen, or supply connection on the same visit when the matching part is available. An uncommon brand part, a seized valve, or a faucet body damaged by corrosion may require us to order the part and book a return visit.

Handle parts and shutoff valves

The age and design of the faucet matter because older fixtures may use parts that are no longer stocked locally, while newer single-handle models may need a brand-specific internal component. A visible drip at the spout is generally simpler to reach than a leak hidden below the sink deck or behind a pull-down hose.

Access changes the work as well. A crowded sink cabinet, rusted mounting nuts, or a shutoff valve that has seized can add removal and isolation work before we can reach the failed part. If a repair becomes a full fixture replacement in a managed property, owner or property-manager approval may also be needed before a new faucet is installed.

Faucet model and sink cabinet

Before calling, note which room has the problem and whether it is the kitchen faucet, bathroom sink faucet, bar sink, or laundry fixture. Tell us whether water is dripping from the spout now, collecting at the base, or showing inside the sink cabinet.

The brand name on the spout, handle cap, or spray head can help us identify the fitting. If you have it, the model number may be printed on the original box, installation sheet, or a label beneath some spray heads.

Let us know roughly when the faucet was installed and whether the cabinet doors open fully around the pipes and shutoff valves. A photo of the faucet and the cabinet plumbing can also show the handle style and hose connections before the visit.

Call The San Antonio Plumber at (726) 200-5953 before a base leak keeps soaking the sink cabinet and damages the wood beneath your faucet.

Next: get in touch, or back to the home page.