Skip to content
The San Antonio Plumber (726) 200-5953

Toilet Repair in San Antonio, TX

Running toilet, weak flush, leak at the base, or overflow? We diagnose the fault.

Call (726) 200-5953 Ask a question

A plumber standing with arms folded on a driveway in front of a house, the back of an open service van behind him stacked with tool cases, coiled hose and a red drain machine

A plunger is the sensible first tool when the bowl water rises or a flush will not clear. It can move a soft blockage in the trap, but repeated plunging stops helping when the tank is not releasing enough water, the bowl is refilling, or something is lodged farther along the toilet passage.

We repair toilets with problems in the bowl, tank, handle, supply line, and base seal. A toilet that will not flush, keeps running, leaks onto the floor, or threatens to overflow should not be left for later, because repeated flushing can send water over the rim or damage the flooring around the base.

Toilet keeps running

You may hear water hissing in the tank long after flushing, see a slow ripple in the bowl, or find that the handle must be held down to finish a flush. Other calls involve a bowl that fills too high, water on the tile around the base, a tank that will not refill, or a toilet that rocks when you sit down.

A running toilet can come from the rubber seal at the bottom of the tank, known as the flapper, while a weak flush may start with the handle chain, tank water level, or bowl passage. Water at the floor can be from the supply connection, tank bolts, or the seal beneath the bowl. These faults can look alike from outside the fixture, but they involve different parts and different repair work once we inspect the toilet.

Toilet inspection and testing

We begin the callout by flushing the fixture, watching the bowl water level, listening for tank refill, and checking the floor and wall behind the toilet for moisture. We inspect the handle, chain, rubber seal, fill valve, supply line, tank bolts, and shutoff valve, then check whether the toilet is stable on the floor.

A straightforward tank inspection and test commonly takes about 20 to 40 minutes. Replacing an accessible handle, chain, rubber seal, or fill valve can often be completed during the same visit, while we may need to book a return visit for a bowl removal, a seized shutoff, damaged floor flange, or a replacement part that must be ordered.

Where a leak is present, we isolate the water at the shutoff before working on the tank or supply connection. We test the flush and refill cycle again after the repair so the tank stops at the proper water line and the bowl clears without continued running.

Shutoff valves and base seals

The age of the tank parts affects the scope of a repair because old rubber, corroded bolts, and brittle plastic can break when a toilet is opened. An accessible tank with a working shutoff generally involves less work than a toilet with a seized valve, rusted hardware, or a supply line that cannot be safely disconnected.

Leaks at the base can also change the work needed. If the bowl must be lifted, we need to assess the floor, the mounting points, and the seal beneath the fixture; a damaged flange or soft flooring may require additional repair before the toilet can be secured again. A part that is no longer made for the tank or needs to be ordered can require a separate return visit.

Tank model and room

Before you call, look inside the tank lid or on the back of the bowl for the manufacturer name and model number. Tell us which bathroom has the problem and whether the fixture is a standard toilet, a dual-flush model, or a wall-mounted unit.

It also helps to note whether water is running into the bowl now, whether the tank refills, and whether water appears at the base only after flushing. Let us know if a cabinet, tight sidewall, or flooring limits access to the shutoff or tank bolts. Call The San Antonio Plumber at (726) 200-5953 before a running tank keeps sending water through the bowl.

Next: sewer line repair, or back to the home page.